UI-8-10-10V-RS-485 HMI Case Protective Film Terminal Keypad

FAQ:

Question: Do the Andover Continuum UI-8-10-10V-RS-485 UI-8-10-10V RS485 UI81010VRS485 replacement Outer Casing Switch Membrane Protective Film come with a warranty?

Answer: Yes, VICPAS provides a warranty for all replacement parts. If you encounter any issues, please get in touch with our support team for assistance.

Question: How long does it take to receive the Andover Continuum UI-8-10-10V-RS-485 UI-8-10-10V RS485 UI81010VRS485 HMI Case Operator Keyboard Overlay after placing an order?

Answer: Standard delivery typically takes 2-4 business days, depending on your location and the selected shipping method. Expedited options may be available upon request.

Question: How to replacing or adding I/O Modules?

Answer: There are two ways to replace an I/O module to minimize the potential for long-term harm to any equipment. The procedure that you follow depends upon the exact installation and the circumstances that exist at the time of replacement. Both procedures are described below. In either case, the controlled equipment must be overridden during the process. If no external method of override exists, the equipment will go off.
Remove all power from the NetController and I/O modules:
1. Turn power supply off.
2. Disconnect the batteries.
3. Replace or add the I/O module.
4. Turn power supply on.
5. Reconnect batteries.
6. Reload NetController
Remove power to the I/O bus only:
1. Ensure that batteries are connected and fully charged.
2. Turn power supply off.
3. On the CyberStation workstation or Command Terminal Interface, cd to the appropriate controller in the command line: type “set IOUPower = off”. The battery will now only power the CPU and modem (if applicable).
4. Replace or add the I/O module.
5. Restore power.
6. If the NetController version is prior to 1.03, type “set IOUPower = on” in the command line in CyberStation or Command Terminal Interface.