IPC 477D PRO 6AV7250-6GD07-0PA0 Touch Screen Panel

Notes on mounting

The Simatic 6AV7 250-6GD07-0PA0 Touch Screen must be mounted securely. Inadequately dimensioned fasteners may cause the 6AV72506GD070PA0 Touch Panel to fall down. Serious physical injury may result. Make sure that fasteners are adequately dimensioned during installation. Make sure to consider the weight and the forces acting on the Siemens 6AV7250-6GD07-0PA0 HMI Touch Glass when dimensioning. This applies in particular to dynamic load of the device. All fasteners including mounting surfaces, support arm systems, and fastening elements such as screws must be able to carry at least four times the weight of the device. Observe any further statutory specifications applying at the location of use of the 6AV7 250-6GD07-0PA0 Touch Membrane and further applicable regulations with regard to fastening the device.
If you are using a support arm system or a pedestal system that does not have IP65 degree of protection or Enclosure Type 4X / 12 (indoor use only), IP65 degree of protection and Enclosure Type 4X / 12 (indoor use only) are voided for the entire device. Spray and water jets as well as penetrating substances can then damage the Simatic 6AV72506GD070PA0 Touch Digitizer Glass. Only use a support arm system or pedestal system that has IP65 degree of protection and Enclosure Type 4X / 12 (indoor use only).