IDEC HG9Z-3DA2PN02 Protective Sheet Overlay Repair

Order each part separately is available

Mounting

Place the HG9Z-3DA2PN02 Front Overlay in a panet cut-out and fasten with the attached mounting clips at four places uniformly. Do not tighten excessively, otherwise the Terminal may be defommed or damaged. When installing the HG9Z-3DA2PN02 Protective Film vertically, make sure that the power input terminal is on the upper side. If the mounting clips are tightened obliquely to the panel, the IDEC HMI may fall off the panel. Please attach this product to press down HG9Z-3DA2PN02 Protective Film in the portion of the mountain of gasket. Once removing especially in the attaching again, be careful. There is a possibility that it may become impossible to maintain waterproof ability.

Notes for Operation

The screen becomes blank when the backlight is burnt out; however, the HG9Z-3DA2PN02 Front Overlay remains enabled. Incorrect touch panel operation will occur when operating the touch panel when the backlight appears to be turned off but is actually burnt out. Please note that this erroneous operation may result in damage. At temperatures over the rated operating temperature, the clock accuracy is affected. Adjust the clock before use. For applications which require clock accuracy, adjust the clock periodically. When more than one button is pressed at the same time, due to the detection characteristics of HG9Z-3DA2PN02 Overlay Film, only the gravity center of the pressed area is sensed and the unit assumes that only one button is pressed. Thus, when more than one button is pressed simultaneously, the resulting operation is not guaranteed.