Fujitsu HMI Touch Screen NC01111-T181 NC01111-T202

The enclosure support to fix the Fujitsu NC01111-T181 NC01111-T202 touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also ensure that the enclosure does not cause miss input by touching the view area. The enclosure edge must be between the View area and the guaranteed active area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and enclosure is elastic. Special design would be required to stop water ingress. The corners of the Fujitsu NC01111-T181 NC01111-T202 touch screen panel glass are conductive so do not touch any metal parts after mounting.

Fujitsu NC01111-T181 NC01111-T202 Touch panels are made of glass, so care must be taken in handling them. Do not stress, pile, bend, lift by the cable or put any stress on the film, for example moving by film face vacuum. In order to clean wring dry a cloth which has been emersed in a natural detergent. DO NOT use any organic solvent, acid or alkali solution. Watch the edge of the NC01111-T181 NC01111-T202 panel when cleaning, again for safety reasons.