Delem DA-41 DA41 DA 41 Terminal Keypad Replacement

The DA-41 DA41 DA 41 Keypad Membrane Delem CNC Controller has several programmable features. These features can be enabled or disabled in Delem DA-41 DA41 DA 41 Membrane Keypad keyboard CNC software. Depending on these features, a number of logical signals can be mapped to the I/O pins of the Delem CNC Controller DA-41 DA41 DA 41. This means the system programmer can enable the necessary signals and assign them to input and output pins. The I/O settings are accessible from the menu of the machine parameters. It should be adjusted by authorized personnel only.

If the Delem Controller DA-41 DA41 DA 41 Keyboard Membrane CNC START or STOP button is pressed for 2 seconds in the automatic mode screen the Delem Automation Controller DA-41 DA41 DA 41 Membrane keypad CNC switch will enter its build in diagnostic screen. In total there are 3 screens, the arrow keys up and down can be used to navigate through the screens. The diagnostic mode can be switched off by pressing the STOP key for 2 seconds again.