Advantech UTC-318GR-ATW0E UTC-318GR-ATB0E Touchscreen Protective Film

Order each part separately is available

Installation Instructions

For mounting the HMI Advantech UTC-318G Series UTC-318GR-ATW0E UTC-318GR-ATB0E Touch Digitizer Glass Front Overlay, it is recommended that more than one person handle the installation process to ensure safety and prevent accidental damage to the Advantech HMI UTC-318GR-ATW0E UTC-318GR-ATB0E Protective Film Touch Screen Panel or any personal injury. When wall mounting, start by selecting the appropriate location on the wall for the wall mount plate. Proceed by marking the positions of the two plate screw holes on the wall and drilling two pilot holes at those marked locations. Next, align the wall mount plate screw holes with the pilot holes and secure the mount plate to the wall by inserting screws into the two pilot holes and tightening them securely. Care should be taken not to drop the Advantech screen UTC-318GR-ATW0E UTC-318GR-ATB0E Front Overlay Touch Membrane during this process. Once the mount plate is securely attached, insert four M4 screws into the holes on the panel PC and tighten them to secure the bracket to the rear panel. It's important to double-check the stability of Advantech touch screen UTC-318GR-ATW0E UTC-318GR-ATB0E HMI Touch Glass Protective Film to ensure a safe and secure installation.