UTC-315HR-ATW0E UTC-315HR-ATB0E Protective Film HMI Touch Glass Repair

Safety Instructions

1. Disconnect the equipment from all power outlets before cleaning. Use only a damp cloth for cleaning. Do not use liquid or spray detergents to clean Advantech HMI UTC-315HR-ATW0E UTC-315HR-ATB0E Touch Screen Monitor Front Overlay.
2. Protect the equipment from humidity.
3. Do not expose HMI Advantech UTC-315H Series UTC-315HR-ATW0E UTC-315HR-ATB0E Protective Film HMI Touch Glass to direct sunlight, or install in an environment with direct sunlight, as this may cause damage.
4. Never pour any liquid into an opening. This may cause fire or electric shock.
5. Place the equipment on a reliable surface during installation. Dropping or letting the equipment fall may cause damage to Advantech screen UTC-315HR-ATW0E UTC-315HR-ATB0E Touch Digitizer Front Overlay.
6. The openings on the enclosure are for air convection. Protect the equipment from overheating. Do not cover the openings.
7. If the equipment is not used for a long time, disconnect it from the power source to avoid damage from transient overvoltage.
8. Do not leave Advantech touch screen UTC-315HR-ATW0E UTC-315HR-ATB0E Protective Film Touch Screen Tablet in an environment with a storage temperature of below -20 °C or above 60 °C as this may cause damage. The equipment should be located in a controlled environment.
9. Be aware that the rear cover may become quite hot during operation. To avoid scalding or personal injury, do not touch the rear cover.
10. All cautions and warnings on the equipment should be noted.