- 365 Days
- Product Line
- QTERM Series
- 800 x 480
- QTERM-G72 Touchscreen
- 7 INCH
Beijer HMI QTERM-G72 Touchscreen Repair Replacement
Beijer QTERM-G72 7 INCH HMI with iX runtime HMI Repair kit
The QTERM-G72 HMI terminal includes a 7" (177 mm), 800 x 480 pixel TFT-LCD widescreen display, resistive touch screen and Ethernet 10/100Base-T interface with two serial ports. Industrially hardened to operate in many environmental conditions, the QTERM-G72 meets NEMA-4X specifications for hose down, icing and salt spray when mounted properly. The QTERM-G72 accommodates the same panel cutout as the QTERM-G70.
The QTERM-G72 comes loaded with Beijer Electronics's Qlarity® 2 object-based programming language at no additional charge. Qlarity allows for fast screen design and easy integration with your current hardware
VICPAS supply Beijer QTERM-G72 Touch Panel with 365 days warranty and support Urgent Worldwide Shipping.
The table below describes the parameters of the Beijer QTERM-G72 HMI Parts.
|Warranty:||365 Days Warranty|
|Size diagonal:||800 x 480 pixel|
|Input voltage:||20 - 30 V DC|
Beijer QTERM-G72 Touch Panel HMI Manuals PDF Download:
Question: How to install the Beijer QTERM-G72 Touch Panel?
Answer:1. Verify that the panel surface around the cutout is clean and free of rough edges. A gasketbuilt into the terminal seals against the panel surface. Dirt or imperfections on the panelmay prevent a proper seal. To achieve a NEMA-4X seal, the panel must maintain a flatnessof no greater than 1 mm overall and no greater than .05 mm/mm locally. Additionally,a Ra surface roughness of 1.6 μm must not be exceeded (standard NEMA-4enclosures).
2.Place the terminal into the panel cutout and verify that the terminal is oriented correctly.The printed labels on the back panel may indicate the orientation. If not, you can determinewhich side should be at the top by the position of the serial port(s) on the back panelas follows:
PortraitWhen looking at the front of the unit, the back panel serial port(s) should be facing left.Refer to Figure 5 for an example of a landscape installation.
3.On the back of the panel, align the terminal mounting ring holes with the mounting studs,and place the mounting ring against the back of the panel.
4. Install nuts and washers (supplied with the terminal) onto each of the four mounting studs.Torque all nuts to 90.4 N cm (8 lbs in) to create a seal between the terminal gasket and thepanel. Avoid overtightening the nuts.
Question: Why the Beijer QTERM-G72 HMI have the chemical resistance?
Answer:Autoflex EBA180L covers the overlay surrounding the screen.
Question: What is Beijer QTERM-G72 Touchscreen and Overlay HMI parts price?
Answer: Submit a fast quote, send VICPAS an email for best price.