|Group||Other Old Beijer HMI Part|
|Min. Order||1 piece|
|Terms of Payment||Western Union, MoneyGram, T/T, Paypal, PayPal, Credit Card|
|Product Line||QTERM Series|
|Resolution||800 x 480|
|Supply||QTERM A7 Touchscreen|
Beijer QTERM-A7 317991 7 INCH HMI with iX runtime HMI Repair kit
QTERM-A7 features a TFT color WVGA (800 x 480 pixels) LCD display, 177 mm (7")diagonal size. The display’s high brightness (500 nit) LED backlight offers good daylightreadability.A clear analog-resistive touch screen covers the entire display area for user input.Two full-speed USB ports are available on the back of the QTERM-A7. These ports can beused to add many other devices, such as a keyboard, mouse or additional mass storage.
The QTERM line of human machine interfaces (HMIs) and operator interface terminals (OITs) came to Beijer Electronics through its acquisition of QSI Corporation in 2010. The initial QTERMs were produced in the early 1990s, many of these are still operational today. Many of the QTERM models are designed for harsh and in some cases extremely rugged deployments.
VICPAS supply Beijer QTERM-A7 Touch Panel with 365 days warranty and support Urgent Worldwide Shipping.
The table below describes the parameters of the 317991 Beijer QTERM-A7 HMI Parts.
|Warranty:||365 Days Warranty|
|Size diagonal:||800 × 480 pixel|
|Input voltage:||20 - 30 V DC|
Question: How to install the Beijer QTERM-A7 Touch Panel?
Answer:1. Verify that the panel surface around the cutout is clean and free of rough edges. A gasketbuilt into the terminal seals against the panel surface. Dirt or imperfections on the panelmay prevent a proper seal. To achieve a NEMA-4X seal, the panel must maintain a flatnessof no greater than 1 mm overall and no greater than .05 mm/mm locally. Additionally,a Ra surface roughness of 1.6 μm must not be exceeded (standard NEMA-4enclosures).
2.Place the terminal into the panel cutout and verify that the terminal is oriented correctly.The printed labels on the back panel may indicate the orientation. If not, you can determinewhich side should be at the top by the position of the serial port(s) on the back panelas follows:
PortraitWhen looking at the front of the unit, the back panel serial port(s) should be facing left.Refer to Figure 5 for an example of a landscape installation.
3.On the back of the panel, align the terminal mounting ring holes with the mounting studs,and place the mounting ring against the back of the panel.
4. Install nuts and washers (supplied with the terminal) onto each of the four mounting studs.Torque all nuts to 90.4 N cm (8 lbs in) to create a seal between the terminal gasket and thepanel. Avoid overtightening the nuts.
Question: Why the Beijer QTERM-A7 HMI have the chemical resistance?
Answer:Autoflex EBA180L covers the overlay surrounding the screen.
Question: What is Beijer QTERM-A7 Touchscreen and Overlay HMI parts price?
Answer: Submit a fast quote, send VICPAS an email for best price.